14 products found for "y1396"

rc-car-online - Home

y1396 Reed valve piston

y1396 Version: y1396/29 - Zenoah G290

Genuine Zenoah piston with machined recess for use with Are reed valve block BJ035. Please note: Differing widths of the remaining webs of the piston skirt are caused by production spread of the pistons.Version:y1396/29 - Zenoah G290y1396/32 - Zenoah G320Content:1 piece

€39.90*

This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.

y1306 JETI-SBEC 6-42V voltage regulator

The switching voltage regulator SBEC is supposed to act as a current supply for receivers and servos. It makes possible to use a wide range of input voltages from 2S up to 10S Li-XX cells. Setup of the output voltage between 5 and 8V is accomplished by a shorting plug jumper. This means that the SBEC is also prepared for use with new higher voltage HV-servos. This voltage regulator is for use in combination with the Hitec Servo HS-900SGS/HS-1000SGT/HS-1005SGT/HS-1100WP and the special LiPo 14.8V/3,600mAh receiver battery y1304. It utilizes a 4S LiPo battery to deliver full battery voltage to the HS-900SGS/HS-1000SGT/HS-1005SGT/HS-1100WP servo with and the usual 6 - to 8 volt supply (depending on the servos) to the rest of the rx system. The output voltage is selectable. We install the required connectors to the regulator. The connection to the T/B servo is designed as a direct power supply, so even the current for the T/B servo does not run through the receiver.The regulator has connectors for battery, Receiver and T/B servo. The steering servos plugs directly into receiver and battery. The JR/universal connector on the battery is for the regulator, the BEC connector is for the steering servo power line.Attention: the switch on the voltage regulator does not disconnect the Hitec HS-1000SGT/HS-1005SGT/HS-1100WP's power output stage from the battery, which has a standby drain of about 6 mA. To prevent deep discharge of the battery, the servo must be disconnected from the battery at the end of the day!For your convenience you could install our new electronic high voltage switch y0767 between servo and battery.Wire loom and heat shrink tubing to add a matching connector to the servos power line are included. Data:Size (w/o wires): 60 x 28 x 10 mmWeight: 29 gramsInput voltage (recommended): 7 to 42 V (2S to 10S LiPo)Output voltage (selectable): 5.0 / 5.5 / 6.0 / 7.0 / 8.0 VOutput current: max. 6,2 A continuous / 12 A impulseContents:1 piece

€74.90*

y1390 Sealed ball bearing 15 x 32 x 9 mm

Fits Area 5ive-T clutch bell holder AREA-5T-009. Both sides sealed (2RS) for increased dirt resistance. Does not fit stock parts!Content:Two pieces

€16.90*

y1376 Full set of gaskets for Zenoah G240, G270, G290, and 4-Bolt CY engines

Full set of gaskets for Zenoah G40, G270, G290, and 4-Bolt CY engines.Set includes:0.4 mm cylinder gasket (Zenoah stock thickness!)1 mm exhaust gasket0.5 mm crankcase gasket0.5 mm isolator gasket0.5 mm carburetor gasket

€12.90*

y1397 Sealed ball bearing 20 x 37 x 9 mm

Genuine HT spare/option part. Fits Area 5ive-T rear uprights AREA-5T-034 on the driveshaft side. Both sides sealed (2RS) for increased dirt resistance. Does not fit stock parts! Content:2 pieces

€14.90*

HT replacement flanged bushing 4 x 5.5, y1096, 4 pcs.

For mounting the brace cam in HT aluminum center diff mounts for Carson / Smartech 4WD cars.Inner diameter 4 mmOuter diameter 5.5 mmWidth 3 mm

€3.90*

2009-04 Cask shaped springs for Mecatech Klick-Shocks, yellow 2,8 mm

These cask shaped springs are especially designed to fit the diameters of Mecatech Klick-Shocks and Mecatech Big Bore shocks.Dimensions:Inner diameter, upper: 20,5 mmInner diameter, lower: 16,5 mmOutside diameter: 29,5 mmLength: 49,5 mmWire diameter: 2,8 mm

€16.90*

y1596 INNOTEC Allround Complete Set

Genuine INNOTEC spare/option part. The RC-car all-round wellbeing set for cleaning, sealing and moisture displacement. Set contents: INNOTEC PE100 silicone spray for plastic and rubber care PE100 was specially developed to protect plastics from external agents. The product penetrates right into the molecular structure of the plastic, which is thus protected from the inside out, remains permanently supple and retains its natural gloss. Content 500 ml Can INNOTEC Multi Spray 1000, moisture displacing lubricant Multi Spray 1000 is a strong moisture displacing lubricant that loosens stuck parts and protects against corrosion. Multi Spray 1000 displaces moisture by penetrating between the substrate and water and then protecting the substrate like a protective film. The product is ideal for numerous applications in the RC hobby. Content 500 ml Can INNOTEC Adhesive remover and degreaser Seal and Bond Remover is a slow evaporating universal degreaser that is also perfect for quickly and efficiently removing all types of adhesive and sealant residue. The product softens most adhesives and sealants to make them easier to remove. Content 500 ml Can INNOTEC Power Clean Metall- und insbesondere Aluminium Reiniger Power Clean ist ein sicherer, schnell wirkender Reiniger/Entfetter für fast alle Arten verunreinigter Metallteile und -flächen. Das Produkt entfernt Bremsstaub, Teer, Unterbodenschutz, Fett und diverse Wachse und jede Art von Verschmutzung. Power Clean ist ein ungefährlicher Reiniger für elektronische Brems- und ABS-Systeme. Da das Produkt den Untergrund nicht angreift, eignet es sich auch besonders zum Entfernen von Teerspritzern sowie Fettund Ölflecken. Content 500 ml Can INNOTEC Multi Clean Universal foam cleaner for all plastic and metal parts on the RC car Multi Clean is a highly effective foam cleaner for countless types of dirt on almost all surfaces that can be easily applied to horizontal as well as vertical surfaces due to a stable active foam while intensively affecting the contaminants. Content 600 ml Can Set consists of:5 Dosen

€59.90* €76.90* (22.11% saved)

This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.

y1366 TURBO-TWIST 325 mm special XXL screw driver

y1366 Version: y1366/01 - Phillips no. 0 / PH0

TURBO-TWIST, 325 mm long screw driver in top quality.Allows easy access to hard-to-reach screws in any 1/5 & 1/6 car.Features:Soft Grip handlesExtra long 325 mm shaftChrome Vanadium hardened and tempered bladesBlackened magnetic tipsVersions:y1366/01 - Phillips No. 0 / PH0y1366/02 - Phillips No. 1 / PH1y1366/03 - Phillips No. 2 / PH2y1366/04 - Flat 1.2 x 8 x 325 mm

€6.90*

y1496 Overall for driver figure for H.A.R.M kart RK-1, hand-crafted

y1496 Color: y1496/03 - Red

Genuine HT spare/option part.Affectionately custom-made hand-sewn overalls suitable for the H.A.R.M Kart RK-1. It is tailor-made and can be exchanged directly against the stock overalls.Available in three different color combinations: y1496/01 - yellowy1496 / 02 - blue y1496 / 03 - red Contents:1 piece

€99.90*

y1392/02 Zenoah Shirt white, size L

Genuine Zenoah spare/option part.Great comfort, natural heat regulation. White with black/red edging on collar and sleeves and grey logo imprint.Machine washable for easy care!Size:L - LargeContents:1 piece

€18.90*

y1392/01 Zenoah Shirt

y1392_01 Size: Red - XXL - Xtra Xtra Large

Great comfort, natural heat regulation. Machine washable for easy care!Available in sizes:XLXXLXXXL

€16.90*

y1392/03 Zenoah weather resistant insulated winter jacket

y1392_03 Size: XL - Extra Large

Genuine Zenoah spare/option part.Weather resistant green Zenoah winter jacket with zipper-removable lining.With Zenoah logo.Sizes:L - LargeXL - Extra LargeContents:1 piece

€49.90*

y1391/01 Zenoah bag

Zenoah linnen bag, top quality, extremely durable Material. Dimensions:Height: 320 mmDepth: 90 mmWidth: 270 mm

€0.99*

14 products found for "y1396"

Filter products

rc-car-online - Home