y0251 Performance carburetor with accelerator pump type: WT-813A
€79.90
Available
Product information "y0251 Performance carburetor with accelerator pump type: WT-813A"
Fits Zenoah G230/240/260/270 engines and their CY/HPI Fuelie clones as well.
Walbro WT-813A carb with accelerator pump, improves low end response when the engine is tuned for maximum performance.
15,88 mm bore, 12,7 mm venturi. Ready for installation with modified shaft already installed.
Contents:
- 1 piece
Login
Alternatives
y0251 Performance carburetor with accelerator pump type: WT-813Walbro WT-813A carb with accelerator pump, improves low end response when the engine is tuned for maximum performance. 15.88mm bore, 12.7mm venturi. Ready for installation with modified shaft already installed. Fits Zenoah G230/240/260/270 engines and their CY/HPI Fuelie clones as well. Fits all Zenoah G230/240/260/270 and 290 engines as well as the respective Chung-Yang (CY) versions, also Losi and HPI Fuelie, Smartech, Carson PT engines, and many others.
Customers also bought
Genuine FG spare/option part. Made from T7075 aluminum with wide epoxy insulator plates to protect against engine heat transfer. Venturi-shaped bore increases engine performance.For easier installation removing the cylinder shroud is recommended .Contents:1 Set
This carburetor supoort sits beneath the air filter and prevents therefore widely arising vibrations.
Genuine Losi spare/option part.The set is for two tires (one pair).Content:1 set
Customers also viewed
Genuine FG spare/option part.Standard carburetor for Zenoah G230/260. Carb has integrated choke.Typ: Walbro WT603B.Contents:1 piece
Wheel nut rear for F1 Cars using M6 Thread on the axle.The Lightscale wheelnut is used in combination with the Lightscale lexan disc to convert F1 rims to an up to date and modern look.Thereby the Lightscale wheel nut works just like a real one in present f1 racing. It is tightened with a 22 open end spanner or socket wrench. Alternatively one may use the special Lightscale toolto tighten or loosen the wheel nut.Due to the use of rifled and conical washers a locking effect is achieved.Due to the high torque load on the bonding of tires on largescale cars, checking the bonding from time to time and re-glueing (y0067) if necessary is unavoidable.The kit contains two wheel nutsas well as four rifled conical washersOptional parts: Tool for Lightscale wheel nuts (item code two wheel nutsas well as four rifled conical washersOptional parts: Tool for Lightscale wheel nuts (item code 50100000)
Genuine FG spare/option part.Carburetor type: Walbro WT-813A.Contents:1 piece
Genuine HT spare/option part. Soft trim for body shell edges and cut-outs. Use speed glue for installation.Contents:1 piece / 3 metersPainting tips:
Content: 300 Zentimeter (€4.97 / 100 Zentimeter)
Genuine FG spare/option part.Sparepart for Walbro WT-813 Carburator.Contents:1 set
