LOS252017 Axle Boot Set Losi DBXL+MTXL 1/5 4WD
€29.99
Available
Product information "LOS252017 Axle Boot Set Losi DBXL+MTXL 1/5 4WD"
Contents:
- 10 pieces
Login
Customers also bought
Genuine Losi spare/option part. Contents:1 piece
Genuine Losi spare/option part.Replacing the pins on DBXL drive shafts LOS252001, LOS252021, LOS252019: Remove set screw completelyOpen bench vise until the pin just fits between the jaws Position shaft on vice, held by a second person if necessaryDrive pin out with light hammer blows using a pin punch or a suitable comparable tool If Loctite was excessively used in the assembly, heating the shaft end may be required. Depending on the thread locking compound, you will strive for a value of 200 - 300°C. The shaft end must not be annealed! An annealed pin will mushroom on impact and make it very difficult to drive it out if not impossible. When installing the new pin from set LOS252020 make sure that the flat section of the pin is positioned under the set screw. The set screw should be just slightly tightened against the pin using high strength thread locker (link). Firm tightening puts the pin under preload and increases the risk of breakage!Contents:1 set
Genuine ATOP spare/option part. Camber rods for Losi DBXL with center section cnc-machined from 6061 aluminum by ATOP. High grade all-metal ball joints at the pivot points provide zero backlash and strength. Fits front and rear.Attention: On a DBXL-E 2.0 these rods can only be used as camber rods, not as steering rods! Dimensions: Hole to hole: 117mm Total length: 135mm Contents:2 pieces
Customers also viewed
Genuine Losi spare/option part. Contents:10 pieces
Genuine Losi spare/option part. Contents:4 pieces
Genuine Losi spare/option part. Content:4 pieces
Low-priced retrofitable disk brake for the rear wheels. Suitable for all 1:5 and 1:6 models and Race-Trucks. In connection with the front disk brake very high brake power, optically very effective. We recommend to steer over 2 servos if you install the front and rear disk brake. We deliver the disk brake without uprughts.Contents:1 piece
Item N° 9473Ball drive set for Leopard Sportsline, setFits for 2WD/4WD Sportsline.Not suitable for front application on 4WD cars!
This air filter oil is designed for lubricating foam filters for on-road and off-road use. It reinforces the filters' efficiency for better carburation and retains dirt, mud and sand particles. Prevents water from penetrating into the filter.It is recommended to put the filter with a little bit oil in a small polybag and work it vigorously by hand. Excessive oil must be pressed out (don't wring the foam!) afterwards.For cleaning the filter please use the special foam cleaner y0523.The filter element must be dry before re-oiling.Content:50 ml
Content: 50 Milliliter (€119.00 / 1000 Milliliter)
Genuine Spektrum spare/option part. Contents:1 piece