LOS252047 Losi CV rear Dogbone MTXL

€49.99*

Prices incl. VAT plus shipping costs

Available

Product number: losi_los252047

EAN: 605482624838

Product information "LOS252047 Losi CV rear Dogbone MTXL"

Genuine Losi spare/option part.

Contents:

2 pieces

0 of 0 reviews

Leave a review!

Share your experiences with other customers.

Login

Your email address

Your password

No reviews found. Share your insights with others.

Similar products

LOS253005 FR/R Shock Shaft & Piston Set Losi DBXL+MTXL 1/5 4WD

Genuine Losi spare/option part. Contents:1 set

€19.99*

LOS253006 Losi Spring Cups/Clips/Shock Ends Losi DBXL+MTXL 1/5 4WD

Genuine Losi spare/option part. Contents:1 set

€29.99*

LOS252017 Axle Boot Set Losi DBXL+MTXL 1/5 4WD

Genuine Losi spare/option part. Contents:10 pieces

€29.99*

LOS252051 Losi Wheel Nut, Black MTXL

Genuine Losi spare/option part.Contents:4 pieces

€19.99*

LOS252014 Clutch Bell Losi DBXL+MTXL 1/5 4WD

Genuine Losi spare/option part. Contents:1 piece

€39.99*

This product is currently not available.

LOS252053 Losi Dogbone, Center MTXL

Genuine Losi spare/option part.Contents:2 pieces

€34.99*

This product is no longer available.

LOS252050 Losi Wheel Hex Black with Pin MTXL

Genuine Losi spare/option part.Contents:4 pieces

€39.99*

LOS252020 Universal Rebuild Kit (2): 1:5 4wd DBXL+MTXL

Genuine Losi spare/option part.Replacing the pins on DBXL drive shafts LOS252001, LOS252021, LOS252019: Remove set screw completelyOpen bench vise until the pin just fits between the jaws Position shaft on vice, held by a second person if necessaryDrive pin out with light hammer blows using a pin punch or a suitable comparable tool If Loctite was excessively used in the assembly, heating the shaft end may be required. Depending on the thread locking compound, you will strive for a value of 200 - 300°C. The shaft end must not be annealed! An annealed pin will mushroom on impact and make it very difficult to drive it out if not impossible. When installing the new pin from set LOS252020 make sure that the flat section of the pin is positioned under the set screw. The set screw should be just slightly tightened against the pin using high strength thread locker (link). Firm tightening puts the pin under preload and increases the risk of breakage!Contents:1 set

€11.99*