Item N° 67366 Rear upper ball joint wishbone, metal/plastic, set
For the Off-Road Competition models Leopeard 2 and Leopard 4 instead of the standard rear upper wishbones. Economically priced version with new steel ball joint and with standard plastic joint on the axle arm side.
0 of 0 reviews
Leave a review!
Share your experiences with other customers.
Login
No reviews found. Share your insights with others.
Genuine FG spare/option part. Completely new revised and in important details improved Mini Block Off-Road tires. The rubber material is more wear resisting, grip and traction were improved and the tire wall was reinforced to prevent a tearing of the rubber. The tire inserts are now stronger and therefore more wear resistant.The FG Mini Block tires are especially well-suited for slightly loose and humid ground. We recommend the M and S version in the front and the rear. The H version with slightly less grip can be used for the front axle. The Mini Block tires are also well-suited as front tires for 2WD models in combination with the Mini Pin tires on the rear axle. These tires fit all 1:6 scale wheels with Ø110mm and a width of approx. 64mm. Suitable inserts are enclosed.Contents:2 pieces
The mounting of the double servo saver enlarges the steering angle at the front axle. The outside front wheel achieves an essentially higher steering angle, therefore the curve radius is reduced and the model becomes more aggressive and faster in curves. This set is suitable for the Leopard 4WD Competition.
y0251 Performance carburetor with accelerator pump type: WT-813Walbro WT-813A carb with accelerator pump, improves low end response when the engine is tuned for maximum performance. 15.88mm bore, 12.7mm venturi. Ready for installation with modified shaft already installed. Fits Zenoah G230/240/260/270 engines and their CY/HPI Fuelie clones as well. y0036/03 Ball-raced tuning carburetor Walbro WT 813-RacingTuning carburetor with accelerator pump.shielded by one steel plates (5 x 8 x 0.3 mm). High quality processed and optimized for racing use! The soft stock screw holding the throttle lever has been replaced with a high strength Allen key screw. Since all screws on the carb are imperial sized, so is the key for this screw. A corresponding bit is included in our tool set y0785, or you can use Allen key wrench y0037/03 as well. Ball-raced version of the Walbro WT-813A carburetor with accelerator pump, improved engine response especially in the lower rpm range when the engine is set for maximum performance. 15.88mm bore, 12.7mm venturi. High quality processed carb, modified with a ball-raced throttle shaft, optimized for rc-car applications. Fits all Zenoah G230/240/260/270 and 290 engines as well as the respective Chung-Yang (CY) versions, also Losi and HPI Fuelie, Smartech, Carson PT engines, and many others.
Hard coated surface for wear protection.Non-standard sizes use two numbers for definition. The second number gives the size of the corresponding ring gear.Module: m=1,5Profile regraded, this means that the number of teeth is changed while the diameter remained constant. The part of the involutes? curve that defines the tooth profile is changed. Positively regraded (lower number of teeth) pinions are stronger and run smoother, the reduced strength of negatively regraded pinions doesn?t really matter.