6409 FG Grip knobbly tyre S OR tyre with insert, 2pcs.

The V-pin competition tire is particularly suitable for tracks with loose and sandy surface. The high tread profile, extended to the tire shoulder requires a high manufacturing cost. This tread design guarantees an extremely high side traction and provides maximum propulsion especially on surfaces like sand and loose soil for optimum. A well proven combination is the use of in the rear and V-pin at the front. By cutting of the tread profile of the V-pin tires you can adjust your car's handling easily. The partly or nearly complete removal of the V-pin tire's tread on the outside of the tire, greatly affects the tire's side bite when cornering.Please take a look at the corresponding pics:Pic A - very high lateral grip = car tends to oversteerPic B - high lateral grip = still sharp steering responsePic C - reduced lateral grip = neutral handlingPic D - low lateral grip = expect the car to understeerOf course, the before mentioned does depend on the track surface!Summarized: removing tread from V-Pin tires on the front axle will reduce oversteering, calm your car and make it easier to drive.When oversteering is extreme (e.g. high grass) you may even start cutting the tread on the inside shoulder. This can prevent your car from those annoying traction rolls.For very loose soil the soft compound is recommended, under normal condition the medium compound is usually your best choice.HPI Baja 5 cars can also use these tires when equipped with special adapters. Dimensions:Diameter: 163 mmWidth: 65 mmInner diameter: 106 mm

Mammoth Supergrip onroad 60 and 80 mm tires on white FG rims complete glued, 1 pair.Mammoth Supergrip onroad tires on FG rims for 1/6 and 1/5 offroad cars.Suitable for asphalt surfaces such as car parks and race tracks.   Racing tyres for your off-road model.VersionWidthOuter diameterFront64 mm153 mmRear78 mm153 mmGlued on genuine FG rims (rear tires using extension rings outside ), with foam rubber inserts included. Rim has 18 mm square drive with reinforcement ring.Please note: based on experience we recommend against using other manufacturers rims and extensions. Since the Mammoth tires provide very good grip the rim and the bonding must withstand high loads. Due to the high torque load on the bonding of tires on largescale cars, checking the bonding from time to time and re-glueing (y0067) if necessary is unavoidable.The Mammoth Supergrip is available in in the following compounds: Super softSoftMediumHardFront tirey0581y0582y0583y0584Rear tirey0591y0592y0593y0594General recommendation:The dirtier the track or the lower the ambient temperatures, the stickier (softer) the rear tires should be.Hint regarding the front tires: 2WD cars should use them one or two grades harder then the rears. 4WD cars usually like the same compound all around.Of course, the softer the tire the higher the wear rate; and this applies to Mammoth Supergrip onroad tires as well.The tires have a special onroad thread pattern but will still provide ideal traction after the pattern has been worn out. The white lettering on the tires has been applied for presentation purpose only. The tires will be delivered with black sidewall.Prices per unit: FrontRearMammoth Supergrip:Pair44,90 EUR49,90 EURTire inserts:Pair13,00 EUR13,00 EURFG rim:Pair14,90 EUR14,90 EURFG extension ring:Pair--.-- EUR14,90 EURMounting:Pair13,00 EUR13,00 EURPrices Total                                                                                          85,80 EUR    105,70 EUR

Genuine FG spare/option part. The FG Super-Grip tires are available in a medium or soft hardness compound. The Super-Grip tire develops more road grip and has a better balanced driving performance on a very uneven ground according to its bigger tire diameter and the improved rubber mixture. Due to the high torque load on the bonding of tires on largescale cars, checking the bonding from time to time and re-glueing (y0067) if necessary is unavoidable.Diameter x width: 165 x 65 mmRim with 18 mm square driveContent:2 pieces

Painted body shell with decals.Die Karosserie passt auch auf Carson Comanche, Carson Stadium Racer, Stadium Truck, Bigfoot Race und Pickup Truck. Bei individueller Anpassung natürlich an nahezu allen 1:6er und auch vielen 1:8er RC-Cars!Measures:Wheelbase: 400 mmWith between the wheels: approx. 255 mmWith in the middle: approx. 235 mmWidth: ca. 250 mmTotal length: ca. 630 mmHeight: ca. 180 mm