500305239/01 Carson Diff Steel Gear Set Steel 24/25/26 Teeth Set for Dirt Attack GP

Steel gearwheel 31 teeth with 18 mm square and 1.5 module for Carson Dirt Attack GP from the gear set Carson 500305239.

CNC-machined from 6061-T6 aluminum by Area RC, significantly stronger and more rigid than any plastic version. The length of the arm is 43 mm. AREA-XL BJ032/01 with 23 teeth, red for KO PRO, JR, Sanwa, Airtronics- and many other Servos with 23 teeth shaft

Suitable for all 1:5 models.Diameter 42 mmBore 10 mmTotal width 18 mmTooth width 11.5 mmModule m=1.5Please pay attention that plastic pinions with two opposite flat spots cannot be used on clutch bells with 90° angle pinion shaft. Then you need a .

Genuine FG spare/option part. Contents:1 piece

Genuine FG spare/option part.For Zenoah G230/240/260/270/290/320 enginesContents:1 piece

The Carson Wild E Attack is basically the same as the GP version, but instead of the gas engine, a brushless drive unit provides propulsion. In addition to the other motorization, a different receiver box which also carries the drive battery well protected is used.The car comes with completely installed Carson 2.4 GHz remote control, incl. transmitter alkalines, brushless motor with ESC and 35 kg steering servo, as well as a tool set.Motor and esc both allow the use of batteries up to 8S. However, we recommend 6S, as there is a very good compromise between driving performance and run time. One should not forget that the motors performance with 6S is already significantly higher than that of the gas-powered version and that much power needs to be mastered in a comparatively lightweight 2WD car. Motorization Spektrum 160A ESC 56112/700 TT Monster Brushless Motor 700kV Technical details: Up to 80 km/h depending on the battery Differential with steel gears Aluminium shocks, dust protected Bead-lock rims with off-road tires Aluminium wheel hex drives Ajustable rear wing Completely ballraced 2WD drivetrain Water protected receiver box Aluminium chassis Driving batteries and a charger are still required for driving

Genuine ARRMA spare/option part. This tough steel 39T Mod1 Safe-D5 Pinion Gear is the perfect part to carry in your RC tool box Features: Strong and durable steel for long-lasting performance in extreme RC conditions Precision manufactured wide tooth profile for smooth operation 'D' shaped hole to match motor shaft profile so drive and brakes are not lost if the set-screw backs-out Suits 8mm motor shaft diameter Precision manufactured threaded set-screw hole E-clip supplied for motor shaft pinion retention Includes 1 x Pinion Gear 1 x Set Screw - M4 x 4mm 1 x E-Clip - 6mm