With these adapter rings you can use springs with 20 mm inner diameter on shocks which are made for 16 mm springs.The set includes two each adapter rings with with the dimensions below and 20 mm spring perches #y6092.Dimensions:Inner diameter: approx. 16.10 mmFlange outer diameter: ca. 24.75 mmHub outer diameter: approx. 19.95 mmFlange height: approx. 1.55 mmOverall height: approx. 5.55 mm
Includes HT-Edition parts set worth over 200.- , consisting of::TT1530/252 Top Tuning 5200 mAh LiPo receiver battery 2S, 7,4V 5CTT0198 Top Tuning Bubble-ExTT1000 Top Tuning high voltage 30 Volt switchy0558 HT Car Bag XXLWhen the original 5IVE-T was introduced the world of 1/5-scale off-road racing changed, and this iconic platform became one of the most successful and influential platforms to date. Now get ready for 2.0! The Losi 5IVE-T 2.0 BND: 1/5 4WD Gas Short Course Truck has all of the unrivaled performance of its predecessor and includes Bind-N-Drive technology, allowing you to pick the transmitter that best fits your lifestyle. The powerful Zenoah G320 32cc engine has been built specifically for the 5IVE-T 2.0.The revised chassis layout reduces the front drive shaft angle for improved durability and increased 4WD balance. Plus, the new rack style bellcrank steering assembly makes for easy Ackermann changes and overall improved steering geometry. Additional advances include an updated front hood, upgraded brakes, and hard anodized bleeder caps and shock bodies for improved shock performance. All this ensures the 5IVE-T 2.0 continues to reign supreme.Key FeaturesGenuine Zenoah G320 32cc engineInnovative Bind-N-DriveSpektrum SR6000T telemetry-ready receiverImproved bar style steering rack with adjustable AckermannImproved center differential orientationImproved drive line angleHeavy-duty brakesInnovative clutch mount with gear mesh braceTough steering and gas/throttle servo braceExtra-large 800cc capacity fuel tank What's in the Box?Losi 5IVE-T® 2.0 BND 4WD SCTSpektrum 6200A DSMR 6-Ch AVC Telemetrie receiverZenoah 32cc Gasoline Pull-Start EngineS900S 1/5 Scale Metal Gear Steering ServoS901T 1/5 Scale Metal Gear Throttle ServoWheel WrenchRod End/Shock End toolMulti WrenchSpark Plug WrenchBind PlugExhaust Gasket2.0mm, 2.5mm, 3.0mm, 4.0mm Allen WrenchesProduct Manual Dimensions Height: 181 mm Length: 965 mm Width: 520 mm Weight: 17 kg Needed to CompleteAppropriate Charger like DYNC0505WTransmitter / receiver eg: DX2E or serial receiver compatible e.g: DX6R87-92 Octane Gasoline2-Cycle Motul Oil e.g: y0813/02Gas can e.g: y0686Contents:1 piece
HURRAX extreme Race tire and insert 175x70 mm HURRAX extreme is one of the most successful tire in large scale off-road racing and specifically designed for astro turf and solid ground. With more than 700 (!) differently designed, closely spaced lugs and the 70 mm wide tread it is reasonably wear resistant and provides optimal grip with good side traction. If this - i.e. on the front axle - is not desired, you may cut the lugs at the tires outer edge to reduce cornering grip. This can be easily done with a small side cutter or strong nail scissors. In order to reduce the edging in the tire on the front axle.This makes a tire less aggressive during cornering and changes the cars behavior towards understeer. It becomes depending on the track conditions (i.e. wet!) a lot more drivable.An optimal vehicle setup can often be achieved by running already used HURRAX extreme tires on the front and new ones on the rear axle.This is especially true for 2WD models. Dimensions:External diameter approx. 175 mmInner diameter approx. 130 mmWidth approx. 70 mmWeight: one glued tire on Hurrax rim: 470 gramsDue to the high torque load on the bonding of tires on largescale cars, checking the bonding from time to time and re-glueing HURRAX extreme Race tire and insert 175x70 mm HURRAX extreme is one of the most successful tire in large scale off-road racing and specifically designed for astro turf and solid ground. With more than 700 (!) differently designed, closely spaced lugs and the 70 mm wide tread it is reasonably wear resistant and provides optimal grip with good side traction. If this - i.e. on the front axle - is not desired, you may cut the lugs at the tires outer edge to reduce cornering grip. This can be easily done with a small side cutter or strong nail scissors. In order to reduce the edging in the tire on the front axle.This makes a tire less aggressive during cornering and changes the cars behavior towards understeer. It becomes depending on the track conditions (i.e. wet!) a lot more drivable.An optimal vehicle setup can often be achieved by running already used HURRAX extreme tires on the front and new ones on the rear axle.This is especially true for 2WD models. Dimensions:External diameter approx. 175 mmInner diameter approx. 130 mmWidth approx. 70 mmWeight: one glued tire on Hurrax rim: 470 gramsDue to the high torque load on the bonding of tires on largescale cars, checking the bonding from time to time and re-glueing (y0067) if necessary is unavoidable. GRP off-road disc rim for tires with approx, 132 mm inner diameter.The closed disc rim features reinforcement ribs on the backside and a protective collar around the wheel nut seat.Dimensions:for tires with an inner diameter of approx. 132 mm and approx. 70 mm widthand an outer diameter of approx. 180 mm (like i.e. GRP / Gandini tires)Weight approx. 172 gramms