Tel. 0049 (0)2151-820200Nauenweg 55, 47805 KrefeldMo-Fr 9:00-18:00 Sa 9:00-13:00 o'clockQuick shipping until 14 o'clock
WK Items (0)
0 EUR
.. is empty

de en WorldLanguage
Tipps & Tricks

Replacing the pins on DBXL drive shafts

- back

Replacing the pins on DBXL drive shafts LOS252001, LOS252021, LOS252019:

  • Remove set screw completely
  • Open bench vise until the pin just fits between the jaws
  • Position shaft on vice, held by a second person if necessary
  • Drive pin out with light hammer blows using a pin punch or a suitable comparable tool
  • If Loctite was excessively used in the assembly, heating the shaft end may be required. Depending on the thread locking compound, you will strive for a value of 200 - 300C. The shaft end must not be annealed! An annealed pin will mushroom on impact and make it very difficult to drive it out if not impossible.
  • When installing the new pin from set LOS252020 make sure that the flat section of the pin is positioned under the set screw. The set screw should be just slightly tightened against the pin using high strength thread locker (link). Firm tightening puts the pin under preload and increases the risk of breakage!


reviews
3.7 3 evaluate:


Comments
Your name:

Your e-mail address:

Your text:



Math result



Our site uses cookies and similar technologies. By using the website, you consent to the use of cookies. You can find more information in our Data protection
Allow